中文简体
English
Light Soaking System + Pulsed Solar Module IV Tester
Product Introduction： This device is mainly used to simulate sunlight and collect the volt ampere characteristic curves of crystalline silicon photovoltaic modules. The device adopts a long arc pulse xenon lamp transient light source, and the light source level meets IEC60904-9 ed3 A+A+A+level. Combined with the bath lighting equipment, it can measure the I-V curve, P-V curve, irradiance line, short-circuit current, open circuit voltage, peak power point voltage, current, fill factor, conversion efficiency, series resistance, parallel resistance, etc. of conventional polycrystalline, monocrystalline Perc, Topcon, BC, heterojunction, perovskite and other battery modules.
Key Parameters
Standard
IEC60904-9:2020
Light type
Xenon lamp
Classfication of light source
Spectral match is 0.875-1.125, class A+Irradiance non-uniformity is ≤1%, class A+Irradiance instability is ≤1%, class A+
Irradiance intensity
700W/㎡~1200W/㎡
Spectrum wavelength
400-800nm
Illumination area
2600mm*1600mm,
Other size can be customized
Other size can be customized
Pulse duration
10-100ms, in step of 1ms
Testing technology
It is equipped with linear scanning, advanced magnetic hysteresis, successiveapproximation testing(SAT), Intelligent testing(IAT) and peak holding testing function.
Measurable cell type
Poly-crystalline, Mono-crystalline, TopCon, HJT, BC,CIGS, GaAs, CdTe and Perovskite
Key parameters of immersion system
Cooling
Water Cooling
Light source lifetime
40000h
Illumination area
2600mm*1600mm,
Other size can be customized
Other size can be customized
