中文简体
English
Pulsed Solar Module IV Tester (For Laboratory)
Product Introduction： This device is mainly used to simulate sunlight and collect the volt ampere characteristic curves of crystalline silicon photovoltaic modules. The device adopts a long arc pulse xenon lamp transient light source, and the light source level meets the IEC60904-9 ed3 A+A+A+level. It can measure the I-V curve, P-V curve, irradiance line, short-circuit current, open circuit voltage, peak power, peak power point voltage and current, fill factor, conversion efficiency, series resistance, parallel resistance, etc. of conventional polycrystalline, monocrystalline Perc, Topcon, BC, heterojunction and other high-capacity battery modules.
Key Parameters
Standard
IEC60904-9:2020
Light type
Xenon lamp
Spectrum wavelength
300-1200nm
Classfication of light source
Spectral match is 0.875-1.125, class A+
Irradiance non-uniformity is ≤1%, class A+
Irradiance instability is ≤1%, class A+
Irradiance non-uniformity is ≤1%, class A+
Irradiance instability is ≤1%, class A+
Irradiance intensity
100W/㎡~1300W/㎡
Illumination area
2600*1600mmn
Other size can be customized
Other size can be customized
Pulse duration
10-100ms, in step of 1ms
Repeatability
＜0.1%
Testing technology
It is equipped with linear scanning, advancedmagnetic hysteresis, successiveapproximation testing(SAT), Intelligenttesting (IAT) and peak holding test function.
Measurable cell type
PERC, TopCon, BC, HJT and other high
capacitance solar modules.
capacitance solar modules.
Optional service
EL testing system, to achieve IV testingand EL testing at a same section.
Temperature chamber, to achieve Panfile testing and measurement of
temperature coefficient. WPVS battery, to achieve absolute measurement.
IAM Rotating bracket, to achieve measurement from diffierent angles. Equip with optical filter for lowirradiance test
Multi-channel temperature sensor for
temperature measurement of multi-points.
Temperature chamber, to achieve Panfile testing and measurement of
temperature coefficient. WPVS battery, to achieve absolute measurement.
IAM Rotating bracket, to achieve measurement from diffierent angles. Equip with optical filter for lowirradiance test
Multi-channel temperature sensor for
temperature measurement of multi-points.
