中文简体
English
AM0 Solar Cell Automatic Sorting Machine
Product Introduction： The AM0 I-V battery automatic sorting machine is mainly used to simulate sunlight and collect the volt ampere characteristic curve of crystalline silicon photovoltaic cells. The equipment adopts a long arc pulse xenon lamp transient light source, and the light source level meets the IEC60904-9 ed3 A+A+A+level. It can measure conventional polycrystalline and single crystal Perc Topcon、BC、 I-V curve, P-V curve, irradiance line, short-circuit current, open circuit voltage, peak power, peak power point voltage, current, fill factor, conversion efficiency, series resistance, parallel resistance, etc. of high-capacity batteries such as heterojunctions.
Key Parameters
Standard
ECSS-E-ST-20-08C Rev.1
Light type
Pulsed xenon lamp
Spectrum wavelength
300-1800nm
Classification of light source
Spectral match is 0.75-1.25, class A
Non-uniformity is ≤2%, class A
Instability is ≤2%, class A
Non-uniformity is ≤2%, class A
Instability is ≤2%, class A
Irradiance intensity
1367W/㎡±10%
Illumination area
2000*500mm
Other size is customizable
Other size is customizable
Pulse duration
10-100ms, in step of 1ms
Postioning
Optical position
Testing technology
It is equipped with linear scanning, advanced magnetic hysteresis, successive approximation technology(SAT), Intelligent testing (IAT) and peak holding test function
Measurable Cell type
GaAs、multijunction GaAs
Optional service
EL testing system can achieve IV and EL testing at a same production section
AOI test system, to test cell appearance defects
Weighing system, to measure cell weight
Film thickness measurement, to measure the film thickness of the cell
AOI test system, to test cell appearance defects
Weighing system, to measure cell weight
Film thickness measurement, to measure the film thickness of the cell
